Questions
Answer the following questions to test your knowledge of this chapter:
- What is the position of SOLIDWORKS sketching in modeling?
- What are the two stages we commonly follow when sketching?
- Sketch the following shape using the MMGS measurement system:
Figure 3.56 – The final output of question 3
- Sketch the following shape using the IPS measurement system:
Figure 3.57 – The final output of question 4
- Sketch the following shape using the CGS measurement system:
Figure 3.58 – The final output for question 5
- Sketch the following shape using the MMGS measurement system:
Figure 3.59 – The final output for question 6
- What are under defined, fully defined, and over defined sketches?
Important Note
The answers to the preceding questions can be found at the end of this book.
