Hardware and software requirements
For this project, you will need the following hardware:
Of course you need an ESP8266 chip. You can, for example, use an Olimex ESP8266 module.
You will also need a temperature sensor. I used a DHT11 sensor, which is very easy to use and will allow us to measure the ambient temperature and humidity.
You will also need a 3.3V FTDI USB module to program the ESP8266 chip. Finally, you will also need some jumper wires and a breadboard.
This is a list of all the components that will be used in this chapter, along with the sources where you can purchase them:
ESP8266 Olimex module (https://www.olimex.com/Products/IoT/MOD-WIFI-ESP8266-DEV/open-source-hardware)
Breadboard 3.3V power supply (https://www.sparkfun.com/products/13032)
3.3V FTDI USB module (https://www.sparkfun.com/products/9873)
DHT11 sensor (https://www.adafruit.com/products/386)
Breadboard (https://www.sparkfun.com/products/12002)
Jumper wires (https://www.sparkfun.com/products/9194)
On the software side, you...
