CHAPTER 8
Interfacing to the Beagle Board Buses

This chapter describes bus communication in detail, explaining and comparing the different bus types that are available on the Beagle boards. It describes how you can configure them for use, and how you can communicate with and control I²C, SPI, and UART devices, using both Linux tools and custom-developed C/C++ code. Practical examples are provided using different low-cost bus devices, such as a real-time clock, an accelerometer, a serial shift register with a seven-segment display, a USB-to-TTL 3.3V cable, and a GPS receiver. Finally, the AM335x DCAN controller is used to send and receive messages to and from a CAN Bus using Linux SocketCAN. After reading this chapter, you should have the skills necessary to begin interfacing almost any type of bus device to the Beagle boards.

EQUIPMENT REQUIRED FOR THIS CHAPTER:

• Any Beagle board
• A real-time clock on a breakout board (e.g., the DS3231)
• ADXL345 accelerometer on an I²C/SPI breakout board...