Building a candy dispenser

Let's build a robot by following the building instructions given next. This is what our robot should eventually look like:

Figure 10.2

Proceed as follows:

1. Take your BOOST Hub and ensure that the batteries are fully charged. The hub is illustrated in the following figure:

   Figure 10.3

2. Take three 1x2 bricks with cross holes and a 1x6 brick and connect them to the BOOST Hub, as shown here:

   Figure 10.4

3. Take a 1x2 plate and connect it to one of the green bricks placed on the BOOST Hub. Then, take a 1x4 plate and place it onto the other two green-colored bricks, as shown here:

   Figure 10.5

4. Now, take a 1x2 brick and connect it to the 1x2 plate, as follows:

   Figure 10.5

5. Then, change the side of the model. Take three 1x2 bricks with cross holes and one 1x6 brick and connect them to the BOOST Hub, as shown here:

   Figure 10.7

6. Take one 1x2 plate and one 1x4 plate. Connect them to the previously attached 1x2 yellow-colored...