Building the scorpion claws
You will need the following pieces:
- Two black double-bent beams
- Two black round elbow connectors
- Four blue axle pins
Start with the two black round elbow connectors. Add a blue axle pin to both sides of each of the black round elbow connectors. Add one of each to the black double-bent beams on the second hole of the long part of the beam, as illustrated in the following image:
Figure 5.42 – Building out the first part of the claws
Each of these will then connect to the 11L black beam on the sides of the robot using the fourth pin hole.
Next, locate the following parts:
- Two black double-bent beams
- Six blue axle connector pins
- Two white axle connectors
- Two black 90-degree axle pins
- Two black connector pins
- Two black 3L beams
Again, you will build two of the same parts for each side of the robot. Begin by adding a blue connector pin to the pin hole right before the...