Time for action – finishing the hull

The hull is pretty close to its final shape. Now, it's time to check the shape and tighten up the dimensions using the following steps:

1. Press 7 on the NumPad to get the Top view.
2. Press Z to toggle from Solid to Wireframe. Press the Tab key to go into Object Mode.
3. Look carefully at the outline of the sloop as compared to the template, as shown on the left of the next screenshot. The boat is wider than the template shows it should be. Making the hull taller apparently made it a little wider too.
4. Press the Tab key again to return to Edit Mode. Press A to deselect all the control points.
5. Press B, and then use the mouse to select the three center sets of vertical control points, as shown in the following screenshot:
   
6. Press S, X, and use the mouse to scale them to the same width as the template shows the boat should be, and then press the LMB.
7. Increment the filename and save the file. In the filename, note that this file is the higher detail version of...