Adjusting Tab and Slot properties
In the previous section, we added the Tab and Slot features using the default options. However, there are many properties that can set the exact size and spacing of tabs and slots.
When editing the Tab or Slot feature, we have to edit the Tab and Slot-Tab feature in the FeatureManager Design Tree (see Figure 8.8). This will allow us to change both the tab and the slot details; it is not possible to edit the Tab and Slot-Slot feature directly:
Figure 8.8: The Tab and Slot-Tab and Tab and Slot-Slot features
- Edit the Tab and Slot-Tab feature by clicking on it in the FeatureManager Design Tree and pressing Edit Feature.
- We can now specify the exact details of the tabs and slots. Firstly, we can specify where the tabs and slots will begin by setting an Offset if this is required.
Select the Offset box and set both offsets to 10mm. These distances are measured from the Start Reference Point and End Reference...
