Search icon CANCEL
Arrow left icon
Explore Products
Best Sellers
New Releases
Books
Videos
Audiobooks
Learning Hub
Conferences
Free Learning
Arrow right icon
Arrow up icon
GO TO TOP
Building Wireless Sensor Networks Using Arduino

You're reading from   Building Wireless Sensor Networks Using Arduino Leverage the powerful Arduino and XBee platforms to monitor and control your surroundings

Arrow left icon
Product type Paperback
Published in Oct 2015
Publisher
ISBN-13 9781784395582
Length 192 pages
Edition 1st Edition
Tools
Concepts
Arrow right icon
Author (1):
Arrow left icon
Matthijs Kooijman Matthijs Kooijman
Author Profile Icon Matthijs Kooijman
Matthijs Kooijman
Arrow right icon
View More author details
Toc

Your first transmission

In this section, you will send your first messages between two XBee modules. The first module will be attached to your computer through the XBee Explorer USB board, using the XCTU program to talk to it. To remove the need for a second Explorer board just for this example, the second module will be connected to an Arduino, which will simply print all data received through the serial monitor.

To let your XBee modules start a network, you will need to have exactly one coordinator module, and one or more router modules (the difference between these will be discussed later). XBee modules will usually default to being a router, so you will need to switch one into coordinator mode, as shown next.

This chapter will show brief instructions on connecting things with the recommended hardware. It is possible to use different hardware too, but it is recommended you read on until the first part of the next chapter, since that contains more details on how the connection actually works and what you should be aware of when figuring out how to connect your hardware.

Using the SparkFun XBee Explorer USB

This is by far the easiest way to connect an XBee module: just plug in the XBee module and connect the USB cable:

Using the SparkFun XBee Explorer USB

Be sure to disconnect the power (USB cable) when changing connections, or (un)plugging XBee modules into adapters and shields, to avoid damaging them.

You might have to install drivers for the FTDI USB-to-serial chip used by the Explorer, though this should have been taken care of if you have already installed the Arduino IDE (the older Arduino boards use the same chip and drivers). See the SparkFun site for more information on using the Explorer boards (https://learn.sparkfun.com/tutorials/exploring-xbees-and-xctu) or installing the FTDI drivers (https://learn.sparkfun.com/tutorials/how-to-install-ftdi-drivers).

If the drivers are installed correctly, a new (virtual) serial port will be made available; you can select it in the XCTU program later.

lock icon The rest of the chapter is locked
Register for a free Packt account to unlock a world of extra content!
A free Packt account unlocks extra newsletters, articles, discounted offers, and much more. Start advancing your knowledge today.
Unlock this book and the full library FREE for 7 days
Get unlimited access to 7000+ expert-authored eBooks and videos courses covering every tech area you can think of
Renews at R$50/month. Cancel anytime