For this chapter, you will require the following:
- A computer with access to the internet.
- A Raspberry Pi 3.
- A set of screwdrivers, M2.5, M3 Posidrive, and some jeweler's screwdrivers are recommended.
- A pair of long nose pliers. Optionally, a set of miniature metric spanners.
- Some electrical tape.
- Hook and loop or Velcro tape.
- Drawing software such as www.draw.io, Inkscape, Visio, or similar software.
- Nylon Standoff Kit with M2.5 and M3 threads. These can be found in many online retailers. (M2 or M2.5 are both fine, but must be M3; you may need more than one kit.)
You will be choosing and purchasing a chassis, motor controller, and battery compartment in this chapter, but do not buy them yet.
Check out the following video to see the Code in Action:
